for Cold Climate Housing and much more

Found 129 results for the keyword ‘Floors’

  • Reinforcing weak floorboards

    Helayna from Toronto, Ontario wrote that a few of her hardwood floorboards simply bend down when you step on them in one area. She is afraid that at some point they might just break through. The ceiling below is finished, so she can't check it out from below. She had a contractor who sugge...
  • Tips on Hardwood Floors

    Leonard (Scotty) Wells, a long time floor installer dropped by to discuss hardwood floor expansion and contraction.His greatest recommendation was to try and control the humidity in the house to keep it as even as possible between summer and winter.Pre-finished floors have less problem of expansi...
  • Screwing down Squeeky Floors -- use a Pocket Jig?

    Leo writes: Hey Jon, my year old house has squeaky ceramic floors in random areas, the sub floor was to be screwed down to prevent this but when I look from the basement I can see the screws poking through were they have missed the floor joist. After complaining, the builder stuck some shimmi...
  • Removing chewing gum

    Do you need to remove chewing gum? It can be found in the strangest places and the removal process will depend on what it is stuck to.Let's start with gum stuck to the bottom of a chair or table, on a hard surface. If it is still soft, start with a scraper of any kind to push off most of it....
  • Laying out sheet flooring in a room which is not square

    Laying out one large piece of sheet flooring to fit into a room that is not square is not always easy. I like to first find the wall that is the straightest, or the one that will be the most visible if there is a pattern on the flooring that will look crooked against an odd angled wall. Tha...
  • Non-Slip steps & patios in tough weather

    The famous outdoor second story steps in downtown Montreal, an area they call Balconville because of all the open balconies with stairways, presents a real safety problem in those icy Montreal winters. The most common anti-slip treatment is to install a jute runner, commonly called Tapis CoC...
  • Tools for working with veneers

    True wood veneer consists of very thin sheets of real wood shaved off of logs. It can look like the grain of plywood if it is peeled off of a rolling log, or look like furniture lumber if it is sliced flat like boards right across the log. It was developed as a way to use sturdy but inexpen...
  • Perfect fits for baseboards

    The subject of baseboards came up when Less from Lannigan, Saskatchewan wanted to know how deep trim nailing should go into the wall. The answer is simple, the length of the nail more complicated. A trim nail should go 3/4 of an inch into the stud of the wall. But then you have to add to t...
  • Can I put hardwood floors down on concrete?

    Dale asks about hardwood floors over concrete.If the concrete floor is above grade, like is common in a new condo, no problem.If the concrete is in a basement, below grade, then you have potential serious moisture problems, and hardwood really doesn't like excessive moisture.Generally it is not r...
  • Central Vacs -- Indoor or Outdoor exhaust?

    Health officials all recommend that central vacuum systems should exhaust outdoors while most installers do not put in an outdoor exhaust pipe.A few conflicting facts:The cost of piping the exhaust air outdoors is about $75 installed.Central vacs are noisy and a few municipalities have begun to...