for Cold Climate Housing and much more

Found 39 results for the keyword ‘Molding’

  • Choosing a mitre saw.

    One of our viewers is looking to redo all the trim in his house so he is wondering which mitre saw he should buy. The variety is very confusing but there are two basic types:  Fixed mitre boxes that go up and down. They will cut mitres, angles to the right or the left and most of them will cut...
  • Hollow Bulkheads over bathtubs.

    Rodney from Hamilton Ontario asks "why is there a bulkhead over most bathtubs? Every home I remodel seems to have the ceiling above the tub furred down about one foot." First of all Rodney, bulkheads are not a requirement of any kind and as far as I know, never were. In fact, they are a very reg...
  • Why are there cracks that come and go in my ceiling?

      Chris from Clarenville, Newfoundland has a mysterious crack in his ceiling that you can see in the photo. It comes and goes with the seasons and nothing appears to be able to keep it closed. Why he asks. Many houses today are constructed with pre-fabricated "trusses" for the ceiling joists an...
  • Jon Eakes & the Singing Nuns of St. Michael's Convent

      THE DEAL I made a deal with the singing nuns of St. Michaels convent in Spokane Washington : If they would teach me how to sing, I would teach them how to repair their convent. My only dissapointment in this large project with HGTV Canada was that they never promoted the show well and the...
  • Truss Up-Lift -- that changing crack between the wall and the ceiling

      In all too many new houses, there is a seasonal problem where in the winter the ceiling actually lifts itself right off the wall in the centre of the house, and then settles down after the heating season.  Even in some older houses this goes on every year.  What causes this crack? Avoiding...
  • Hiding Cracks You Cannot Close

      Truss uplift causes cracks between the wall and the ceiling that open and close every year and you cannot plaster or caulk them shut.  For details on the cause and solutions to this problem follow this link. If you cannot do the major work required to prevent this crack from opening, or you j...
  • Plastic repair and replacement -- Three good products

      MOLDABLE PLASTIC -- RESUABLE Utile Plast is a great British product that I stumbled upon -- plastic granules that you put into very hot water - they soften - then you mold them into anything you want. You can shove the soft plastic into a nut and when cool you have a plastic bolt -- or form t...
  • Cutting crown moldings with a mitre saw.

    Cutting crown moldings can be simple and it can be difficult. First you want to check if the corner you are putting the molding into is in fact 90 degrees. If you don't check that you can get real frustrated with your mitre saw. 88 or 92 degree walls require different mitre cuts. Over the years...
  • A great new tool for measuring angles - The SawSet

    A great new tool for measuring angles – The SawSet.  Cabinet makers and finished carpenters have always used two legged devices that you could set to any angle, lock down and transfer that angle to something else. But to measure angles, we have always been limited to reading impossible little ray...