for Cold Climate Housing and much more

Found 107 results for the keyword ‘Basement’

  • Straightening 2x4's in a stud wall

      When you build that basement wall with economy lumber, and one stud is just not flat with the others, there is a way to fix that quickly to end up with a flat wall.             IDENTIFY THE BULGING OUT SIDE OF ANY STUD Then in the middle of the bow, saw cut about 2/3rds of the way ...
  • Where should basement furnace ducts be placed?

    Doug from Manilla, Ontario checked this site for basement heating systems: "I read the section? on cold air returns in the basement, however I could not find anything on where hot air vents should be placed. Do they need to be at the floor level or at the ceiling level?" In the house above the f...
  • Stopping sewage back-up in the basement floor

    INSPECT, MAINTAIN OR INSTALL BACKFLOW DAMPERS UNDER THE BASEMENT FLOOR BEFORE DOING ANY RENOVATION WORK IN A BASEMENT. Installing a backflow valve between you and the city requires cutting into the concrete floor.  With our changing weather, this valve is almost always necssary and generally cod...
  • Peeling paint on a foundation wall.

    Michele in Hamilton, Ontario needs to repaint her cinder block walls on the outside of the basement. But a close look at a photo that she sent us showed a lot of deep holes or pock marks in the blocks. Not only the paint was peeling off, but the block itself was breaking off.  This is a sign o...
  • Adjusting a Jack Post (TelePost)

    Jill writes: HI, my mom lives in a house built in 57'.She has a big crack in the wall above the doorway. How do you adjust the telepost to accommodate the settling of the property. Which way do you turn the post to adjust it, how much etc, -------Response I assume that the cracks are right abov...
  • OVERVIEW:Improper exhaust fans can pollute your home -- could even kill you

    More and more people are asking for powerful kitchen range hoods or bathroom exhaust fans. The logic appears simple, increase the power of the exhaust fan and get rid of pollutants quicker. In more and more modern homes which have been weather-stripped and sealed against cold air leaks and heat l...
  • Basement Perimeter Drainage and Leaking Foundations

    This article deals with walls below grade, foundation walls.  For insulating above grade cinder block walls see How do you Insulate a Brick and Block construction as well as Insulating an Above Grade Block Wall from the Inside. The best way to prevent water from leaking into the basement is not ...
  • BASEMENT: BATTS OR RIDIG FOAM BOARDS?

    Fiberglass batts, mineral wool batts and all kinds of rigid foam boards are commonly used to insulate basements both inside and outside. One of the critical rules when insulating basements on the inside is that there must be no air space between the insulation and the wall. (see no air space beh...
  • Weather Restrictions: Adhesive for foam insulation

    Connect to your favourite weather forecaster and look for the following conditions:   Category: Adhesives     Product: Adhesive for foam insulation Temperature Limitations: Check the package: one manufacturer says above -30 C (-22 F) while another says above +15 C (+60 F). Rain Limitations: A...
  • Insulating a foundation with embedded floor joists

      Certain parts of Canada, particularly in the Winnipeg region, have a traditional construction technique that presents serious challenges when you want to insulate a basement -- the ends of the joists are actually embedded in the concrete foundation wall.  Chris, from Winnipeg, asked for some f...