for Cold Climate Housing and much more

Found 50 results for the keyword ‘Wiring’

  • Legality of DIY electrical and plumbing work

    NEW CONSTRUCTION In the interests of health and safety a number of trades are controlled by law, most particularly plumbing and electricity. The degree to which plumbing and electrical work are actually regulated varies from jurisdiction to jurisdiction. For instance almost all work performed in...
  • How to install an electrical box where there is no stud.

    To see all of this on video visit the Drywall section of the Learning Curve. When you need to install an electrical box in a specific location and there is no stud to attach it to, we call that ReWork -- getting a box in where it is impossible or difficult to attach to a stud.  Most electrical b...
  • Techniques for Installing Drywall

    Electrical Boxes with no Studs

  • How do you cover up an old chandelier electrical box?

    One viewer wanted to get rid of her centre room chandelier in favour of floor standing lamps. So just how do you cover that hole in the ceiling? First remove all the electrical connections and cap off each wire with a cap or wire connector. If two or three wires are already tied together, keep ...
  • What is an air tight electrical box?

    We all know that electrical boxes are the often the source of cold air drafts. They are equally the route by which warm moist air escapes from our houses. In fact, the National Research Council of Canada has calculated that up to 30 litres of water can pass through a single electrical box in one ...
  • Opting out of Hydro Quebec's Smart Meter program and alternatives

    Alternatives to paying hydro to not install a smart meter In Quebec as in some other jurisdictions, the electrical utility has opened the door to refusing the installation of Smart Meters by consumers -- but at a consideral penality.  Initially, in 2012, Hydro Quebec is imposing a $137 charge ju...
  • New circuit protection: Arc Fault Interrupters

    Overload protection Fuses and circuit breakers will stop the electricity in a wire when the load is excessive or there is a short circuit. They prevent overheating of wires from too much electricity trying to flow through a wire that is not large enough to handle it. Stray current protection G...
  • Re-wiring a lamp.

      Here are a few tips when it comes to re-wiring an old lamp.     Use the existing wire to pull the new wire through. You need to join them in a way that does not create a lump in the wire.           Avoiding a lump On the old pair of wires, cut one wire shorter than the other and s...
  • Pro: Wire Up-Sizing for Energy Efficiency and Cost Savings

    A fresh look at household wiring may change the wire sizes we use in some residential lines. The electrical code establishes wire sizes based on fire safety considerations. When an electrical load is run through a wire, the resistance in that wire creates heat. The maximum amperage for a given w...
  • Which is better -- Fuses or Circuit Breakers?

    In some ways, the old fashioned fuse is actually better than the circuit breakers. To make sure I got my facts right on this one I visited George Brown College in Toronto to talk to one of the instructors in the electrician's apprentice programs. Fuses are 100 % reliable. When they get hot, the...