The table saw is real good for cutting lines parallel to edges -- but how do you cut tapers where the two sides are not parallel?
Well, that takes a "taper jig".
Learning Curve 126
I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon
Send me new comments on this article by email
Please note that comments now need to be approved before appearing on the site to combat spam problems. Sorry for the delay!