Jon Eakes
Ask Jon Eakes
for Cold Climate Housing and much more

Table Saw Basics Videos

Miter slot slop Adjustments

If you have worked through the two previous videos you know that the miter slot is the basis of all line-up on the table saw. 

Now, what do we do when our miter gauge wiggles in that all important slot? 

We can't change the slot -- so watch the video to learn how to adjust the miter gauge and take out the slop.

 

« Last Watched « Previous

Learning Curve 97

Add A Comment

  Your Comments

Showing

Viewing from newest to oldest – Reverse
Subscribe by RSS

Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!