Jon Eakes
Ask Jon Eakes
for Cold Climate Housing and much more

Table Saw Basics Videos

Fence to miter slot Adjustments

Tradition has it that we line up the fence to the blade to get a parallel cut, but lining up to a static blade can in fact set the fence un-parallel to the actual cut. 

If you have done a dynamic line-up of the blade to the miter slot in the last video, you can now line up any setting of the fence to the miter slot.  Doing so you are setting the fence parallel over a three foot distance and not just measured to a 10" blade -- and you are lining it up to the dynamic cut of the blade as well. 

It is all simpler on video -- take a look.

 

« Last Watched « Previous

Learning Curve 96

Add A Comment

Showing

Viewing from oldest to newest Reverse
Subscribe by RSS

Be The First To Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!