for Cold Climate Housing and much more

Fastening Things To Drywall

Here you will see hooks, anchors and other ways to hang things on drywall when you don't have a stud where you want one.  In fact our camera shows you what happens inside the wall at the same time as we install them on the outside.

 

Learning Curve 60


Add A Comment

  Your Comments

Showing 1 comment

Viewing from oldest to newest Reverse
Judy Urbanek on July 25, 2016 22:29

What kind of Stud Finder would you recommend?

Hello Judy,
That's a tough question. There are so many stud-finders on the market ranging from $15 to $200, and none of them work all the time!

Probably the very old fashioned little magnet on a pivot was the most accurate as it would swing only if you were right over the head of a drywall screw. Most of the others look for differences in density in the wall, but in a very old house, the studs are so dry that often they don't show up, or often not accurately.

Many modern stud-finders can be switched to find wood, metal or electric wires. Good to know before driving a screw. I have 12 different ones on my shelf, and there have been times when none of them agreed with each other.

One tip is that most studs are 16" or 24" on centre. Mark out several and then measure. Erase the marks that don't fit that sequence.
--Jon

Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!